Users Guide

92 | Configuring and Using Device Groups in AirWave Dell PowerConnect W-AirWave 7.4 | User Guide
Configuring WLANs for Cisco WLC Devices
In Cisco WLC Config, WLANs are based on SSIDs or VLANs that are dedicated to Cisco WLC controllers.
Perform the following steps to define and configure WLANs for Cisco WLC controllers.
1. Go to the Groups > Cisco WLC Config page, and select WLANs in the navigation pane at left. This page
displays the SSIDs or VLANs that are available for use with Cisco WLC devices, and enables you to define
new SSIDs or VLANs. Figure 47 illustrates this page.
2. To change the ID/position of a WLAN on the controller by dragging and dropping, set the toggle to yes. Note
that the by setting this flag to yes, AMP will display a mismatch if the WLANs in the desired and device
config differ only on the order.
Figure 47 Groups > Cisco WLC Config > WLANS page illustration
3. To add or edit SSIDs or VLANs that are dedicated to Cisco WLC devices, either select the Add New SSID/
VLAN button, or select the pencil icon for an existing SSID/VLAN. A new page appears comprised of four
tabs, as follows:
 General—Defines general administrative parameters for the Cisco WLC WLAN.
 Security—Defines encryption and RADIUS servers.
 QoS—Defines quality of service (QoS) parameters for the Cisco WLC WLAN.
 Advanced—Defines advanced settings that are available only with Cisco WLC devices, for example, AAA
override, coverage, DHCP and DTIM period.
Figure 48 Groups > Cisco WLC Config > WLANs > Add New SSID/VLAN > General Tab Illustration
NOTE: Refer to Cisco documentation for additional information about Cisco WLC devices and related features.