Users Guide

Dell PowerConnect W-AirWave 7.4 | User Guide Configuring and Using Device Groups in AirWave | 95
Configuring Wireless Parameters for Cisco Controllers
This section illustrates the configuration of Wireless settings in support of Cisco WLC controllers. The navigation
for Wireless settings is illustrated in Figure 54.
Figure 54 Groups > Cisco WLC Config > Wireless Navigation Illustration
Configuring Cisco WLC Security Parameters and Functions
AirWave enables you to configure many security settings that are specific to Cisco WLC controllers. This section
supports four overriding types of configuration, as follows:
 AAA, to cover both RADIUS and TACACS+ server configuration
 Priority Order
 Wireless Protection Policies
 Web Auth
Figure 55 illustrates these components and this navigation:
Figure 55 Groups > Cisco WLC Config > Security Navigation Illustration
Configuring Management Settings for Cisco WLC
AirWave allows you to configure of SNMP and Syslog Server settings for Cisco WLC controllers. You can
configure up to four trap receivers on the Cisco WLC including the AMP IP that can be used in Global Groups.
To define SNMP and server settings, go to the Groups > Cisco WLC Config > Management page, illustrated in
Figure 56.