Users Guide
102 | Configuration Reference Dell PowerConnect W-AirWave 7.4 | Configuration Guide
3. Select Add or Save. The added or edited profile appears on the Mobility Switch page, and on the details page.
Profiles > Mobility Switch > Port Switching
Port Switching creates a switching profile that can be applied to any interface, interface group, or a port-channel.
Perform these steps to configure a Mobility Switch > Port Switching profile:
1. Select Profiles > Mobility Switch > Port Switching in the Navigation pane. The details page summarizes the
current profiles of this type.
2. Select the Add button to create a new Port Switching profile, or select the pencil icon next to an existing
profile to edit. Complete the settings as described in Table 46:
Duplex Auto Sets the duplex to one of the following parameters:
Auto—Configures auto mode.
full—Configures full duplex mode.
half—Configures half duplex mode.
Speed (Mbps) Auto Sets the speed to one of the following parameters:
Auto—Negotiates bandwidth dynamically between 10 and 1000/10000.
10—10 Mbps.
100—100 Mbps.
10m_100m—10 to 100 Mbps.
1000—1 Gbps.
10000—10 Gbps.
Flow Control off Sets the flowcontrol to one of the following parameters:
Auto—Configures auto mode.
lossless—configures lossless mode.
on—configures on mode.
off—configures off mode.
Table 46 Profiles > Mobility Switch > Port Switching Profile Settings
Field Default Description
General Settings
Folder Top Set the folder with which the profile is associated. The drop-down menu displays
all folders available for association with the profile.
Name Blank Enter the name of the profile.
Other Settings
Access Mode VLAN (1-4094) 1 Specify the VLAN ID for the port, when the switch-port mode is access.
Native VLAN Mode (1-4094) 1 Specify the VLAN for incoming untagged packets, when the switch-port mode is
trunk.
When a packet goes out of a trunk interface in native VLAN, it will be untagged. By
default, VLAN 1 is the native VLAN. The native VLAN should be part of the trunk
allowed VLANs.
Max Bandwidth Rate Limit
(50-100)
50 Specify the storm control bandwidth.
Table 45 Profiles > Mobility Switch > Ethernet Link Profile Settings (Continued)
Field Default Description