Users Guide

24 | Dell PowerConnect W Configuration in AirWave Dell PowerConnect W-AirWave 7.4 | Configuration Guide
 “General Profiles Guidelines” on page28
10. Provision multiple Dell PowerConnect W AP Groups on one or more controllers by putting the controllers
into an AMP group and configuring that group to use the selected Dell PowerConnect W AP Groups. With
global configuration enabled, configure such Dell PowerConnect W AP Groups settings on the Group > Dell
PowerConnect W Config page. With group configuration, use the Dell PowerConnect W AP Groups. The
following section of this document provides additional information:
 “General Dell PowerConnect W AP Groups Procedures and Guidelines” on page27
11. As required, add or edit AP devices. The following section of this document has additional information:
 “Supporting APs with Dell PowerConnect W Configuration” on page30
12. Each AP can be assigned to a single Dell PowerConnect W AP Group. Make sure to choose an AP Group that
has been configured on that controller using that controller's AMP Group. Use the APs/Devices > List,
Modify Devices field and the APs/Devices > Manage page. You can create or edit settings such as the AP
name, syslocation, and syscontact on the APs/Devices > Manage page. For additional information, refer to
“Supporting APs with Dell PowerConnect W Configuration” on page30.
Figure 16 APs/Devices > Manage Page Illustration (Partial Display)
13. Navigate to the APs/Devices > Audit page for the controller to view mismatched settings. This page provides
links to display additional and current configurations. You can display all mismatched devices by navigating to
the APs/Devices > Mismatched page.