Deployment Guide

Motorola 5.x software is not supported by AirWave.
HP
®
Devices
The following HP devices are supported for monitoring and software upgrades. These devices are available within the
VisualRF product catalog and can be selected when setting up device-specific triggers and alerts. In addition, these
devices can be set up as trap receivers, and the SNMP traps can be seen on the System > Syslog & Traps page.
In VisualRF, the utilization value for HP devices will be 0 because AirWave does not get utilization values for these
devices.
Table 4: HP supported firmware and devices
Firmware Version Model Type
Validated up to software version 5.7.1.0-12275
l HP MSS430
l HP MSM460
l HPMSM466
l HPMSM720
(controller)
Validated up to software version 5.5.3.0-01-10326 HP MSM710 (controller)
Support for additional HP devices is described at the end of the document.
Wired Ethernet Switches
Any standalone Ethernet access switch that supports the standard SNMP MIB-II objects for wired switches can be
monitored by AirWave.
AirWave will collect the uptime and name/location/contact information for switches (or any device that supports
SNMP). For port information, AirWave relies on the IF-MIB to collect byte counts.
MAC addresses are collected from the BRIDGE MIB and RFC1213 MIB (ARP table) in order to determine AP port
assignments and identify possible rogue dvices on the network.
Some switches have additional support in AirWave:
Cisco
l Automated discovery through SNMP
l Model & software version identification
l CDP neighbor information and extended port error stats
l 3750 stack information
Juniper®
l Automated discovery through SNMP
l Model & software version identification
l Rogue AP detection is supported using the Q-BRIDGE MIB
HP ProCurve
l Automated discovery through SNMP
4 Dell Networking W-AirWave 7.7 | Supported Infrastructure Devices