Users Guide
Dell PowerConnect W AirWave 7.1 | User Guide Discovering, Adding, and Managing Devices | 131
Figure 79 Device Setup > Discover > Add New Scan Set Page Illustration
3. Select the Ne
twork(s) to be scanned and the Credential(s) to be used. You may select as many networks and
credentials as you would like. AWMS defines a unique scan for each Network-Credential combination.
4. Click the Add
button to create the selected scans. The newly defined scans appear in a list at the top of the
Device Setup > Discover page.
5. To edit an existing scan, click the penci
l icon next to the scan on the Device Setup > Discover page.
6. When ready, proceed to the next task, “Running a Scan Set” on page131.
Running a Scan Set
Once a scan has been defined on the Device Setup > Discover page, AWMS can now scan for devices. Perform
these steps.
1. Browse to the Devi
ce Setup > Discover page and locate the Discovery Execution area at the top of the page.
This section lists all scan sets that have been defined so far. Figure 80 illustrates this page.
Note: Scheduling an HTTP scan to run daily on your network can help you to discover rogues. Some consumer access points,
most D-Link, Linksys, NetGear models, do not support SNMP and are found only on the wired side with an HTTP scan. These
devices are discovered only if they have a valid IP address. Proper credentials are not required to discover these access points.
Wireless scans and the Aruba Management Client discover these rogues without any special changes.