Users Guide

Dell PowerConnect W AirWave 7.1 | User Guide Creating and Using Templates | 187
aaa group server radius wds server
10.2.25.162 auth-port 1645 acct-port 1646
wlccp authentication-server infrastructure method_wds
wlccp wds priority 200 interface BVI1
wlccp ap username wlse password 7 095B421A1C
%endif%
The following example sets an AP as a WDS Master Backup with the following lines:
%if wds_role=backup%
aaa authentication login method_wds group wds
aaa group server radius wds server
10.2.25.162 auth-port 1645 acct-port 1646
wlccp authentication-server infrastructure method_wds
wlccp wds priority 250 interface BVI1
wlccp ap username wlse password 7 095B421A1C
%endif%
SCP Required Settings in Templates
A few things must be set up before enabling SCP on the Groups > Basic configuration page. The credentials
used by AWMS to login to the AP must have level 15 privileges. Without them AWMS is not be able to
communicate with the AP via SCP. The line "
aaa authorization exec default local" must be in the APs
configuration file and the AP must have the SCP server enabled. These three settings correspond to the following
lines in the APs configuration file.
 username Cisco privilege 15 password 7 0802455D0A16
 aaa authorization exec default local
 ip scp server enable
The username line is a guideline and will vary based on the username being set, in this case Cisco, and the
password and encoding type, in this case 0802455D0A16 and 7 respectively.
These values can be set on a group wide level using Templa
tes and TFTP. Once these lines are set, SCP can be
enabled on the Groups > Basic configuration page without problems.
Supporting Multiple Radio Types via a Single IOS Template
Some lines in an IOS configuration file should only apply to certain radio types (that is, 802.11g vs. 802.11b). For
instance, lines related to speed rates that mention rates above 11.0Mb/s do not work for 802.11b radios that
cannot support these data rates. You can use the "
%IF variable=value% … %ENDIF%" construct to allow a
single IOS configuration template to configure APs with different radio types within the same Group. The below
examples illustrate this usage:
interface Dot11Radio0
…
%IF radio_type=g%
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0
%ENDIF%
%IF radio_type=b%
speed basic-1.0 2.0 5.5 11.0
%ENDIF%
%IF radio_type=g%
power local cck %CCK_POWER%
power local ofdm %OFDM_POWER%
%ENDIF%
…