Users Guide

Dell PowerConnect W AirWave 7.1 | User Guide Access Point Notes | 311
1. If you have not done so already, connect to the AP (see above), click OK, and press Enter.
2. When the Summary Status screen appears after you have connected to
the AP, reboot the AP by unplugging
and then re-plugging the power connector.
3. When the AP reboots and the Summary St
atus screen reappears, type :resetall and press Enter.
4. Type yes, and press Enter to confirm the command.
5. After the AP reboots and the Express Setup screen appe
ars, reconfigure the AP by using the terminal
emulator or an Internet browser.
Cisco IOS Dual Radio Template
A dual-radio Cisco IOS AP template is included as reference.
! Template created from Cisco Aironet 1240 IOS 12.3(11)JA1 'newName'
! at 2/12/2007 10:14 AM by user 'admin'
<ignore_and_do_not_push>ntp clock-period</ignore_and_do_not_push>
version 12.3
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
hostname %hostname%
enable secret 5 $1$ceH2$/1BN2DQpOoBAz/KI2opH7/
ip subnet-zero
ip domain name Aruba.com
ip name-server 10.2.24.13
no aaa new-model
dot11 ssid OpenSSID
authentication open
power inline negotiation prestandard source
username newpassword password 7 05050318314D5D1A0E0A0516
username Cisco password 7 01300F175804
bridge irb
interface Dot11Radio0
%enabled%
no ip address
no ip route-cache
ssid OpenSSID
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
channel %channel%
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
%if interface=Dot11Radio1%
interface Dot11Radio1
no ip address
Note: The :resetall command is valid for only two minutes after the AP reboots. If you do not enter and confirm the:resetall
command during that two minutes, reboot the AP again.