Users Guide

82 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.1 | User Guide
Editing Columns on the Groups > List Page and Additional Pages
Perform the following steps to edit the columns that appear on the Groups > List page. All additional list and
reports pages in AWMS Version 7.0 and later allow you to edit the presence and sequence of columns in this
manner:
1. Above the list or report, click Edit Columns. The supported columns appear in a popu
p window, as illustrated
in Figure 41:
Figure 41 Edit Columns Illust
ration for the Groups > List Page
2. To remove one or more columns from the G
roups > List page, click to remove the check mark from the
associated checkbox.
3. To change the sequence in which columns ap
pear on the Groups > List page, place your cursor over the drag-
and-drop icon, left click, move the column to the new position, and release.
4. Click Save to retain your settings. The G
roups > List page displays your changes.
The following pages include columns abl
e to be edited for data display:
 Home > Search (results)
 Helpdesk > Incidents
 Groups > List
 Groups > Monitor
 Groups > Cisco WLC Config
 APs/Devices > List
 APs/Devices > New
 APs/Devices > Up
 APs/Devices > Down
 APs/Devices > Mismatched
Up/Down Status
Polling Period
Column represents the time between Up/Down SNMP polling periods for each device in the group.
Detailed SNMP polling period information is available on the Groups > Basic configuration page. Note that
by default, most polling intervals do not match the up/down period.
Duplicate Column represents a hyperlink, and the link creates a new group with the name Copy of <Group Name>
with
the same group configuration.
Table 37 Groups > List Page Fields and Default Values (Continued)
Column Description
Note: When you first configure AWMS, there is only one default group labeled Access Points. If you have no other groups
configured, refer to “Configuring Basic Group Settings” on page83.