Users Guide

Dell PowerConnect W AirWave 7.1 | User Guide Configuring and Using Device Groups in AWMS | 83
 APs/Devices > Ignored
 Users > Connected
 Users > All
 Users > Guest Users
 Users > Tags
 Reports > Generated
 Reports > Definitions (defining report setup)
 Device Setup > Discover
 Device Setup > Aruba Configuration (and several additional pages in this section)
 AMP Setup > NMS
 AMP Setup > RADIUS Accounting
 RAPIDS > Rogue APs
 RAPIDS > Score Override
Configuring Basic Group Settings
The first default device group that AWMS sets up is the Access Points group, but you can use this procedure to
add and configure any device group. Perform these steps to configure basic group settings, then continue to
additional procedures to define additional settings as required.
1. Navigate to the Gr
oups > List page. Existing device groups appear on this page.
2. To create a new group, click Add. Enter a gro
up name and click Add. The Group > Basic page appears.
To edit an existing device group, click the manage (wrench)
icon next to the group. The Group > Basic page
appears. If you hover your cursor over an existing group’s manage (wrench) icon, a popup menu appears after
a moment, and allows you to click Basic, Templates, Security, SSIDs, AAA Servers, or Radio to edit those
pages as desired.
Figure 42 illustrates the Gr
oups > Basic page. Page content differs according to the devices that a group
contains. This page may change over t
ime as you add or remove devices from the group.