Users Guide

88 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.1 | User Guide
11. To configure settings specific to Cisco WLC, locate the Cisco WLC section and adjust these settings as
required. Table 45 describes the settings and default values.
12. To configure Proxim/Avaya specific settings locate the Proxim/A
vaya section and adjust these settings as
required. Table 46 describes the settings and default values.
13. To configure HP ProCurve 420 specific settings, locate the HP ProCurve 420 se
ction and adjust these settings
as required. Table 47 describes the settings
and default values.
Table 45 Cisco WLC F
ields and Default Values
Setting Default Description
SNMP Version 2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to
WLC controllers.
CLI Communication Tel net Sets the protocol AWMS uses to communicate with Cisco IOS devices. Selecting SSH
uses the secure shell for command line page (CLI) communication. Selecting Telnet
sends the data in clear text via Telnet.
Note: When configuring Cisco WLC controllers, refer also to “Configuring Wireless Parameters for Cisco Controllers” on
page110.
Table 46 Proxim/Avaya Fields and Default Values
Setting Default Description
SNMP Version 1 Drop-down menu specifies the version of SNMP used by AWMS to communicate to the
AP.
Enable DNS
Client
No Enables the DNS client on the AP. Enabling the DNS client allows you to set some values
on the AP by hostname instead of IP address. If you select Yes for this setting, additional
DNS fields display.
Primary DNS
server
Blank Sets the IP address of the Pr
imary DNS server.
Secondary DNS
server
Blank Sets the IP address of the Secondary DNS server.
Default DNS
d
omains
Blank Sets the default DNS domain used by the AP.
HTTP Server Port 80 AWMS sets this port as the HTTP server
port on all Proxim APs in the group.
Country Code United States Configures AWMS to derive its time settin
gs based on the country of location, as
specified in this field.
Table 47 HP ProCurve 420 Fields and Default Values
Setting Default Description
SNMP Version 2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to the
AP.
ProCurve XL/ZWeSM CLI
Communication
Tel net Sets the protocol AWMS uses to communicate with
ProCurve XLWeSM devices.
Selecting SSH will use the secure shell for command line page (CLI) communication.
Selecting telnet will send the data in clear text via telnet.