Users Guide

94 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.1 | User Guide
Configuring Group SSIDs and VLANs
The Groups > SSIDs configuration page allows you to create and edit SSIDs and VLANs that apply to a device
group. Perform these steps to create or edit VLANs and to set SSIDs.
Figure 44 illustrates an example of the Groups > SSID
s page.
Figure 44 Groups
> SSIDs Page Illustration
1. Navigate to the Gr
oups > List page and select the group for which to define SSIDs/VLANs by clicking the
group name. Alternatively, click Add to create a new group, define a group name. In either case, the Groups >
Monitor page appears.
2. Select the Groups
> SSIDs configuration page. Table 54 describes the information that appears for SSIDs
and VLANs that are currently configured
for the device group.
Note: WLANs that are supported from one or more Cisco WLC controllers can be configured on the Groups > Cisco WLC Config
page.
Note: AWMS reports users by radio and by SSID. Graphs on the AP and controller monitoring pages have check boxes that
display bandwidth in and out based on SSID. Furthermore, AWMS reports can also be run and filtered by SSID. There is an option
on the AMP Setup > General page to age out SSIDs and their associated graphical data; by default, this is set to 365 days.
Note: Multiple VLANs and SSIDs are supported only on Cisco access points.
Table 54 Groups > SSIDs Fields and Descriptions
Field
SSID Displays the SSID associated with the VLAN.
VLAN ID Identifies the number of the primary
VLAN SSID on which encrypted or
unencrypted packets can pass between the AP and the switch.
Name Displays the name of the VLAN.
Encryption Mode Displays the encryption on the VLAN.
First or Second Radio Enabled Checkbox enables the VLAN, SSID and Encryption Mode on the radio
control.