Users Guide

ManualsBrandsDell ManualsNetwork CardW-AP105

AP-105 Mounting Kit

Installation Guide

0510651-02 | July 2010 1

Introduction

The AP-105 Wall Mounting kit provides two options, with built-in security features, for mounting your

AP-105 to a wall. Use the Box Mount Bracket to install the AP over wall box and use the Wall Mount

Bracket to install the AP directly on a wall.

The kit includes the following:

z 1x plastic Box Mount Bracket

z 1x plastic Wall Mount Bracket

Figure 1 AP-105-MNT

Figure 2 AP-105-MNT-DC

Required Tools

z A screwdriver that matches the screws used for mounting your brackets.

z An M5 (Metric) or 3/16" (Standard) hex key.

NOTE

This installation guide pertains to both the AP-105-MNT and AP-105-MNT-DC. The AP-105-MNT can only be

used with an AP that is powered by Power Over Ethernet (PoE), while the AP-105-MNT-DC allows the use of a

DC power source.

AP105_008

Box Mount Bracket Wall Mount Bracket

AP105_008

Wall Mount Bracket

Box Mount Bracket

Summary of content (6 pages)

PAGE 1
AP-105 Mounting Kit Installation Guide Introduction The AP-105 Wall Mounting kit provides two options, with built-in security features, for mounting your AP-105 to a wall. Use the Box Mount Bracket to install the AP over wall box and use the Wall Mount Bracket to install the AP directly on a wall. NOTE This installation guide pertains to both the AP-105-MNT and AP-105-MNT-DC.
PAGE 2
Installation 1. Before securing your mount to a double-gang box or directly to the wall, route the ethernet cable through the openings show in Figure 3. Figure 3 Cable Routing Wall Mount Bracket Box Mount Bracket Cable Route to ENET Port AP105_010 Cable from Gang Box 2. Install your mounting bracket. For the Wall Mount Bracket (Figure 4): a. Before installing your Wall Mount Bracket, install the appropriate wall anchors. Screws and wall anchors are not included. b.
PAGE 3
The box mount bracket can also be installed over a double-gang wall box. Use the same steps as above to install it over a double-gang wall box, however the installation requires a third screw. For more details, see Figure 6.
PAGE 4
3. Connect the ethernet cable to the ethernet port (ENET) on the back of the AP. 4. Secure the AP to the mounting bracket by aligning the mounting holes on the back the AP with the mounting post on the bracket. 5. Push the AP against the posts and downward until the posts engage the slots at the top of the mounting holes. See Figure 7 and Figure 8 for more details.
PAGE 5
6. To remove the AP from the mounting bracket, begin by inserting an M5 or 3/16" hex key into the hole shown in Figure 10. 7. Use the hex key to depress the tab on the AP and push the AP up, releasing the AP from the mounting post on the bracket.