Users Guide

2 AP-220-MNT-W2 Wall Mount Kit | Installation Guide
Ethernet Cable Behind AP
1. Route the Ethernet cable(s) through the large opening in the center of the mount.
2. If required, route the power cable through the bottom right of mounting bracket.
3. Install the mounting bracket as described in “Installing the Mounting Bracket” on page3.
Figure 2 Ethernet cable behind AP
Using The Ethernet Cable Adapter
1. Install Ethernet cable adapter(s) by sliding the female end of the adapter into the slot behind the access
on the side of the mounting bracket. The adapter is secured when it clicks into place.
2. If required, route the power cable through the bottom right of mounting bracket.
3. Install the mounting bracket as described in “Installing the Mounting Bracket” on page3.
Figure 3 Using the Ethernet cable adapter
AP-220_23
AP-220_24