Users Guide

AP-130-MNT-W1

Installation Guide

0510430-03 | September 2013 1

The AP-130-MNT-W1 Wall Mount kit allows you to mount your 130 Series access point to a wall.

1. Begin by attaching the wall mount adapter to the wall as shown in Figure 1 or Figure 2.

a. Install any necessary wall anchors. Wall anchors are not included in this kit.

b. Align the screw holes in the mounting bracket with the previously installed anchors or demarcated

screw points.

c. Insert the screws to secure the mounting bracket. Screws are not included in this kit.

Figure 1 Attaching the Adapter to a Wall

Figure 2 Attaching the Adapter to a Wall (Alternate)

AP-130_003

AP-130_006

PAGE 1
AP-130-MNT-W1 Installation Guide The AP-130-MNT-W1 Wall Mount kit allows you to mount your 130 Series access point to a wall. 1. Begin by attaching the wall mount adapter to the wall as shown in Figure 1 or Figure 2. a. Install any necessary wall anchors. Wall anchors are not included in this kit. b. Align the screw holes in the mounting bracket with the previously installed anchors or demarcated screw points. c. Insert the screws to secure the mounting bracket. Screws are not included in this kit.
PAGE 2
. Attach any necessary cables and/or antennas to the AP. 3. Attach the AP to the secured mounting adapter as shown in Figure 3. a. Align the AP with a mounting adapter, placing the AP so that it’s mounting tabs are at an angle of approximately 30 degrees to the adapter. 4.