Users Guide

ManualsBrandsDell ManualsTVs & monitorsW-AP224/225

AP-220-MNT-W2 Wall Mount Kit

Installation Guide

0511290-02 | August 2013 1

Package Contents

 AP-220-MNT-W2 Mounting Bracket

 2x Ethernet Cable Adapter

 T8 Torx Security Screw

Installation

Complete the following steps to install your access point using the AP-220-MNT-W2.

Ethernet Cable Routing Options

There are three options for routing the Ethernet cable depending the placement of your AP in relation to the

source of the Ethernet cable.

Ethernet Cable From Below AP

1. Route the Ethernet cable(s) through the channel in the rear of the mount.

2. Loop the Ethernet cable(s) over the top of the mount and direct the cable(s) through the opening leading

to the AP’s Ethernet ports.

3. If required, route the power cable through the bottom right of mounting bracket.

4. Install the mounting bracket as described in “Installing the Mounting Bracket” on page3.

Figure 1 Ethernet cable from below the AP

This mount kit supports multiple AP models. All installation images show the 225 AP.

AP-220_22

Summary of content (4 pages)

PAGE 1
AP-220-MNT-W2 Wall Mount Kit Installation Guide This mount kit supports multiple AP models. All installation images show the 225 AP. Package Contents  AP-220-MNT-W2 Mounting Bracket  2x Ethernet Cable Adapter  T8 Torx Security Screw Installation Complete the following steps to install your access point using the AP-220-MNT-W2. Ethernet Cable Routing Options There are three options for routing the Ethernet cable depending the placement of your AP in relation to the source of the Ethernet cable.
PAGE 2
Ethernet Cable Behind AP 1. Route the Ethernet cable(s) through the large opening in the center of the mount. 2. If required, route the power cable through the bottom right of mounting bracket. 3. Install the mounting bracket as described in “Installing the Mounting Bracket” on page 3. AP-220_23 Figure 2 Ethernet cable behind AP Using The Ethernet Cable Adapter 1.
PAGE 3
Installing the Mounting Bracket 1. Install any necessary wall anchors. Wall anchors are not included in this kit. 2. Align the screw holes in the mounting bracket with the previously installed anchors or demarcated screw points. 3. Insert the screws to secure the mounting bracket. Screws are not included in this kit. Ensure that no Ethernet cable(s) are obstructing the screw holes. AP-220_19 Figure 4 Attaching the Adapter to a Wall 4. Attach any necessary cables and/or antennas to the AP. 5.
PAGE 4
AP-220_20 Figure 5 Attaching the AP to the Mounting Bracket AP-220_21 Figure 6 Completed Installation 4 AP-220-MNT-W2 Wall Mount Kit | Installation Guide