Users Guide

AP-220-MNT-W1 Wall Mount Kit

Installation Guide

0511288-03 | August 2013 1

1. Begin by attaching the wall mount adapter to the wall as shown in Figure 1 or Figure 2.

a. Install any necessary wall anchors. Wall anchors are not included in this kit.

b. Align the screw holes in the mounting bracket with the previously installed anchors or demarcated

screw points.

c. Insert the screws to secure the mounting bracket. Screws are not included in this kit.

Figure 1 Attaching the Adapter to a Wall

Figure 2 Attaching the Adapter to a Wall (Alternate)

This mount kit supports multiple AP models. All installation images show the 225 AP.

AP-220_11

AP-220_14

PAGE 1
AP-220-MNT-W1 Wall Mount Kit Installation Guide This mount kit supports multiple AP models. All installation images show the 225 AP. 1. Begin by attaching the wall mount adapter to the wall as shown in Figure 1 or Figure 2. a. Install any necessary wall anchors. Wall anchors are not included in this kit. b. Align the screw holes in the mounting bracket with the previously installed anchors or demarcated screw points. c. Insert the screws to secure the mounting bracket. Screws are not included in this kit.
PAGE 2
. Attach necessary cables and/or antennas to the AP. 3. Attach the AP to the secured mounting adapter as shown in Figure 3. a. Align the AP with a mounting adapter, placing the AP so that it’s mounting tabs are at an angle of approximately 30 degrees to the adapter. 4. Pushing toward the wall, rotate the AP clockwise until it clicks into place (see Figure 3).