Users Guide

3. Click Add Configuration.
The WMI Configuration page opens.
Figure 118: WMI Configuration Page
4. Specify the WMI Configuration parameters as described in Table 68, then click Save Entry.
Field Action/Description
IP Subnets/ IP
Addresses
1. Enter either one or more IPsubnets or one or more IPaddresses. For multiple entries,
separate multiple IP addresses with commas.
NOTE: The WMI configuration can be for a single IP address or a subnet. These credentials are
used when a WMI scan is initiated.
Domain 2. Enter the name of the Windows domain for logging into the device(s) that you are scanning.
Username 3. Enter the username for the device or subnet specified.
Password 4. Enter the password for the device or subnet specified.
Description 5. Optionally, enter a description of this SNMP configuration (recommended).
Table 68: WMI Configuration Parameters
6. Repeat this procedure for additional entries if needed.
7. When finished, click Save.
You return to the Profile Settings page, where you can see that the WMI configuration has been added
successfully (see Figure 119).
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Monitoring | 159