Users Guide

Figure 121: Initiating the Seed Devices Scan
3. Enter the appropriate information in the Initiate Scan dialog as described in Table 69.
Field Action/Description
Server 1. From the drop-down list, select the W-ClearPass Policy Manager server.
If the W-ClearPass server is in a cluster, the list will display the cluster node IPaddresses
that you can choose.
NOTE: Once you select the node, the network discovery scan starts with that node.
Scan Depth 2. Specify the Scan Depth by selecting the desired number from 1 to 5.
The Scan Depth numbers indicate the levels of the network you want to scan. The default is
Scan Depth 3.
The seed devices are, by default, at Scan Depth 1. Starting from the seed device, the next
device level is Scan Depth 2, and so on, until the scan reaches the scan depth specified
here.
Seed Devices 3. Enter the IP addresses of one or more seed devices from which the network scan should
proceed.
Separate multiple device IP addresses with commas.
Table 69: Initiating Network Discovery Scan Parameters
4. Click Start.
You return to the Network Discovery page, which now indicates the following:
n The Start Time and End Time for the seed device scan.
n The number of Endpoints and Devices connected to the seed device.
n The Status of the scan operation, which shows initally as "Scheduled," then "In Progress," and finally,
"Completed."
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Monitoring | 161