Users Guide

310 | Posture Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
The Patch Management Health Checks configuration page opens:
Figure 274: Configuration Page for the Patch Management Application
11.Specify these parameters as described in the following table:
All checks might not be available for some products. Where checks are not available, they are shown in a disabled
state.
Parameter Action/Description
Product-specific checks To check whether any patch management application (any vendor) is running
on the end host, clear the Uncheck to allow any product check box.
Select Patch Management
Product
Select a patch management product vendor.
This option is enabled only if the Product-specific checks check box is
checked.
Product version is at least Enter the minimally recommended product version number.
This option is enabled only if the Product-specific checks check box is
checked.
Status Check Type Specify the Status Check Type to check whether the Patch Agent is enabled.
The W-ClearPass Policy Manager server compares the Patch Agent Status
sent by OnGuard Agent with the configured value. If the Patch Agent Status
value is different from configured value, the client is treated as unhealthy.
If Auto-remediation is enabled, OnGuard Agent changes the Patch Agent
Status on the client to the configured value. Select any of the following options:
Table 157: Patch Management Parameters