Users Guide
468 | Network Access Devices Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
Parameter Action/Description
Authentication
Key
Specify the SNMP v3 with authentication option (SHA or MD5).
NOTE: The EAP-MD5 authentication type is not supported if you run W-ClearPass Policy Manager
in FIPS mode.
NOTE: Authentication Key is available in SNMP v3 only.
Privacy Key Specify the SNMP v3 with privacy option.
NOTE: Available in SNMP v3 only.
Privacy
Protocol
Choose one of the available privacy protocols:
n DES-CBC
n AES-128
NOTE: Available in SNMP v3 with Privacy only. Privacy allows for encryption of SNMP v3
messages to ensure confidentiality of data.
Table 261: Add Device > SNMP Read Settings Parameters (Continued)
SNMP Write Settings Parameters
Use the SNMPWrite Settings tab to define values that allow W-ClearPass Policy Manager to write to
(manage) the device using SNMPv1, SNMPv2, or SNMPv3.
1. From the Add Device page, select the SNMP Write Settings tab.
The SNMP Write Settings dialog opens:
Figure 463: Add Device > SNMP Write Settings Dialog
2. Enter the SNMP Write Settings parameters as described in Table 262.
Parameter Action/Description
Allow SNMP
Write
Toggle to enable or disable SNMP write.
Default VLAN Specify the VLAN port setting after the SNMP-enforced session expires.
SNMP Write
Setting
Specify the SNMP Write setting for the device. You can set any of the following options:
n SNMP v1 with community strings
n SNMP v2 with community strings
Table 262: Add Device > SNMP Write Settings Parameters