Users Guide

Parameter Action/Description
n SNMP v3 with no Authentication
n SNMP v3 with Authentication using MD5 and no Privacy
n SNMP v3 with Authentication using MD5 and with Privacy
n SNMP v3 with Authentication using SHA and no Privacy
n SNMP v3 with Authentication using SHA and with Privacy
NOTE: The MD5 authentication type is not supported if you use W-ClearPass Policy Manager
in FIPS mode.
Community
String
Enter the community string for sending the traps.
Verify Reenter the community string for sending the traps.
Table 262: Add Device > SNMP Write Settings Parameters (Continued)
CLISettings Parameters
Use the CLI Settings tab to enable or disable the CLI, and define user names, passwords, and port settings for
accessing the CLI.
1. From the Add Device page, select the CLI Settings tab.
The CLI Settings dialog opens:
Figure 464: Add Device > CLI Settings Dialog
2. Enter the CLI Settings parameters as described in Table 263:
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Network Access Devices | 469