Users Guide

Figure 465: Add Device > OnConnect Enforcement Dialog
2. Enter the OnConnect Enforcement parameters as described in Table 264.
Parameter Action/Description
Enable Select this check box to enable W-ClearPass OnConnect on the network access device being added.
Port Names Specify the names and descriptions of the ports to be enabled for OnConnect Enforcement (see the
next section for details). You can do so in two ways:
l Click Query Ports.
l You can also a enter port names manually as a comma-separated list.
Only the ports added in the Port Names field will have OnConnect Enforcement enabled.
For example, if you add the port names Fa1/0/3,Fa1/0/5, when clients connect to any of these ports
on the specified network device, OnConnect Enforcement is triggered on that network device.
NOTE: An empty string will enable OnConnect on all ports. W-ClearPass will attempt to determine
the uplink or upstream trunk ports; however, it is recommended to explicitly remove those ports.
Query Ports To display the list of ports on the current server, click Query Ports.
Add to Port
Names
Once the list of ports are displayed, select the desired ports from the displayed list, then click Add
to Port Names.
The selected ports are added to the Port Names field.
Table 264: Add Device > OnConnect Enforcement Parameters
Querying and Selecting Port Names for OnConnect Enforcement
To query and select port names for a network access device for OnConnect Enforcement:
1. From the Configuration > Network > Devices page, select the network device.
2. From the Edit Device Details page, select the SNMP Read Settings tab (see Table 261 above).
3. In the Allow SNMP Read parameter, select the Enable Policy Manager to perform SNMP read
operations check box.
4. Select the OnConnect Enforcement tab.
5. Click the Query Ports button.
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Network Access Devices | 471