Users Guide

512 | Administration Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
Specify the W-ClearPass Network Services parameters as described in the following table:
Service Parameters Action/Description
SnmpService
SNMP Timeout Specify the seconds to wait for an SNMP response from the network device.
SNMP Retries Specify the number of retries for SNMP requests.
LinkUp Timeout Specify the seconds to wait before processing link-up traps.
If a MAC notification trap arrives in this time, the SNMP service does not try to poll the
switch for MAC addresses behind a port for link-up processing.
IP Address Cache
Timeout
Specify the duration in seconds for which MAC-to-IP lookup response is cached.
Uplink Port Detection
Threshold
Specify the limit for the number of MAC addresses found behind a port after which the
port is considered an uplink port and not considered for SNMP lookup and enforcement.
The default value is 5, with a range from 0 to 20.
SNMP v2c Trap
Community
Specify the community string that must be checked in all incoming SNMP v2 traps.
SNMP v3 Trap
Username
Specify the SNMP v3 Username to be used for all incoming traps.
SNMP v3 Trap
Authentication
Protocol
Specify the SNMP v3 Authentication protocol for traps.
The options are: MD5, SHA, or empty (to disable authentication).
NOTE: The EAP-MD5 authentication type is not supported if you use W-ClearPass Policy
Manager in FIPS mode.
SNMP v3 Trap Privacy
Protocol
Specify the SNMP v3 Privacy protocol for traps.
The options are: DES_CBC, AES_128, or empty (to disable privacy).
NOTE: The DES_CBC privacy protocol is not supported if you use W-ClearPass Policy
Manager in FIPS mode.
SNMP v3 Trap
Authentication Key
Specify the SNMP v3 authentication key and privacy key for incoming traps.
SNMP v3 Trap Privacy
Key
Device Info Poll
Interval
Specify the time (in minutes) between polling for device information.
Certificate Auth
Table 279: Service Parameters > W-ClearPass Network Services