Users Guide

524 | Administration Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
Figure 514: System Monitoring Configuration Dialog
4. Specify the System Monitoring configuration parameters as described in the following table:
Parameter Action/Description
System Location Specify the location of the W-ClearPass Policy Manager appliance.
System Contact Specify the contact information of the W-ClearPass Policy Manager appliance.
Engine ID A unique identifier for the SNMP v3 agent. The engine ID is used with a hashing function
to generate keys for authentication and encryption of SNMP v3 messages.
The default value for the Engine ID is 6620000004030662.
The Engine ID is automatically generated when you enable the stand-alone SNMP agent.
SNMP Configuration
Version Specify the SNMP version from the options V1, V2C, or V3.
The SNMP parameters on this page vary based on the SNMP version selected.
Community String V1 and V2C: Enter and reenter the community string for sending traps. This is applicable
only for SNMP V1 and V2C versions.
Username V3 only: Specify the user name to use for SNMP v3 communication.
Security Level V3 only: Select any of the following options:
l NOAUTH_NOPRIV (No authentication or privacy):When you select this security level,
only the SHA authentication protocol is available.
l AUTH_NOPRIV (Authentication but no privacy): When you select this security level,
the MD5 and SHA authentication protocols are available.
l AUTH _PRIV (Authenticate and keep the communication private): When you select
this security level, the MD5 and SHA authentication protocols are available.
Authentication
Protocol
V3 only: Select the authentication protocol from MD5 or SHA.
These protocols vary depending on the security level that you selected in the Security
Level field.
NOTE: The MD5 authentication protocol is not supported in FIPS mode.
Table 286: System Monitoring Parameters