Users Guide

Figure 519: Creating an IPsec Tunnel Dialog

5. Specify the Create IPsec Tunnel parameters as described in the following table, then click Create:

Parameter Action/Description

Local Interface Specify the local Management interface.

Remote IP Address Specify the IP address of the remote host.

IPsec Mode Select one of the following IPsec modes:

n Tunnel

n Transport

IKE Version Select the version of the Internet Key Exchange (IKE) protocol from the options: 1 or

IKE Phase 1 Mode This parameter is enabled when you select IKE Version 1. IKE Phase 1 Mode is

set by default to Main.

PRF The PRF (pseudorandom function) parameter is enabled when you select IKE

Version 2.

Select one of the following PRF options:

n PRF-HMAC-SHA1

n PRF-HMAC-SHA256

n PRF-HMAC-SHA384

n PRF-HMAC-MD5

Encryption Algorithm Select one of the following encryption algorithms:

n AES128

n AES256

Table 289: Create IPSec Tunnel Parameters

Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Administration | 529