Users Guide

534 | Administration Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
Figure 525: Creating a VLAN
5. Specify the Create VLAN parameters as described in the following table, then click Create:
Parameter Action/Description
Physical
Interface
Enter the physical port on which to create the VLAN interface.
This is the interface through which the VLAN traffic will be routed.
NOTE: Make sure your network supports tagged 802.1Q packets on the selected
physical interface.
VLAN Name Enter the name for the VLAN interface.
This name is used to identify the VLAN in the list of network interfaces.
VLANID Specify the 802.1Q VLAN identifier. Enter a value between 1 and 4094.
The VLAN ID cannot be changed after the VLAN interface has been created.
NOTE: VLAN ID 1 is often reserved for use by network management components.
Avoid using this VLAN ID unless you know it will not conflict with a VLAN already defined
in your network.
IP Address Enter the IP address of the VLAN.
Netmask Enter the netmask for the VLAN.
Table 291: Server Configuration > Create VLAN Parameters
FIPS Page
This section provides information on using W-ClearPass Policy Manager in Federal Information Processing
Standards (FIPS) 140-2 approved mode.
The U. S. Government developed FIPS 140-2 to define procedures, architectures, cryptographic algorithms,
and other security techniques for use in government applications and networks that use cryptography.
When running in FIPS Approved mode, W-ClearPass Policy Manager utilizes a FIPS 140-2 validated
cryptographic module. Support is not available for non-approved authentication methods such as EAP-MD5
and MD5 digest algorithms.
For details on the Validated FIPS 140-1 and FIPS 140-2 Cryptographic Modules, see:
http://csrc.nist.gov/groups/STM/cmvp/documents/140-1/140val-all.htm#2577