Users Guide

636 | Administration Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
Figure 631: Adding Attributes to the RADIUS Enforcement Profile
Tunnel-Private_Group-Id
4. Click Click to add....
a. Type: Select Radius:IETF.
b. Name: Select Tunnel-Private_Group-Id.
c. Value: Enter the value configured for the Tunnel-Private_Group-Id attribute on the controller.
Session-Timeout
5. Click Click to add....
a. Type: Select Radius:IETF.
b. Name: Select Session-Timeout.
c. Value: Enter 21600 (which equals six hours in seconds).
Tunnel-Type
6. Click Click to add....
a. Type: Select Radius:IETF.
b. Name: Select Tunnel-Type.
c. Value: Select VLAN.
Termination-Action
7. Click Click to add....
a. Type: Select Radius:IETF.
b. Name: Select Termination-Action.
c. Value: Select RADIUS-Request.
8. Click Save.
You return to the Enforcement Profiles page. The following message is displayed:
Enforcement profile "Infoblox RADIUS Enforcement" added
Creating an Infoblox Enforcement Policy
This section describes how to create an enforcement policy to act against the "Infoblox Notify" and "Infoblox
RADIUS Enforcement" profiles so that external devices can authenticate against this policy.
For details on configuring enforcement policies, see Configuring Enforcement Policies on page 371.
To create an Infoblox Enforcement Policy: