Users Guide
Figure 648:
8. Specify the Schedule Change settings:
a. If you wish to run the MACaddress filter now, select Now.
b. If you wish to schedule the MAC address filter for later, select Later and specify the Start Date and
Start Time.
c. When finished with the Schedule Change settings, click Save & Close.
Integrating W-ClearPass with Juniper Networks SRX
This section provides the following information:
l Adding a Juniper Networks SRX Endpoint Context Server
l Adding a Context Server Action to the Juniper SRX Server
l Viewing or Modifying Juniper Networks SRX Endpoint Context Server Actions
l Creating a Juniper SRX Enforcement Profile
l Creating a Juniper SRX Enforcement Policy
l Defining a Juniper SRX Wireless Service
For more information about the parameters that you must enter to configure this endpoint context server,
consult Juniper Network's documentation.
Integrating W-ClearPass with Juniper Networks SRX typically tags the username context, as well as the external
devices being authenticated, along with its respective MAC address, which further simplifies IP address
management on the Juniper SRX server side.
This section describes the configurations that you must make on the W-ClearPass server in order for the
W-ClearPass server to send data to a Juniper Networks SRX server.
Adding a Juniper Networks SRX Endpoint Context Server
To add a Juniper Networks SRX Endpoint Context Server:
1. Navigate to Administration > External Servers > Endpoint Context Servers.
The Endpoint Context Servers page appears.
2. Click Add.
The Add Endpoint Context Server dialog appears. This dialog opens in the Server page.
3. From the Select Server Type drop-down, select Juniper Networks SRX.
Server Page
The following dialog is displayed (see Figure 649).
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Administration | 645