Users Guide

708 | Administration Dell Networking W-ClearPass Policy Manager 6.6 | User Guide
l Failed to download script file = 262 (0x106)
l Execution level is set to “User” but the user is not logged on, so OnGuard was not able to launch the script =
263 (0x107)
OnGuard Global Agent Settings
This section provides the following information:
l About Global Agent Settings
l Global Agent Settings Parameters for OnGuard Agents
l Global Agent Settings: Run OnGuard As Parameter
About Global Agent Settings
Use the Global Agent Settings page to configure the global parameters for OnGuard agents.
1. Navigate to the Administration > Agents and Software Updates > OnGuard Settings page.
2. Click the Global Agent Settings link at the top-right corner.
The Configure Global Agent Settings page opens.
Figure 705: Configure Global Agent Settings Page
3. To add additional Global Agent Settings parameters, select Click to add...
4. Name: Select the desired Global Agent Setting (see Table 379).
5. Value: Specify the appropriate value.
6. Repeat these steps as necessary for each additional setting, then click Save.