Users Guide

Figure 725: Adding an Event Source
3. Specify the Add Event Source parameters as described in Table 384.
Parameter Action/Description
Name 1. Enter the IP address of the device that will send Syslog events to W-ClearPass.
Description Optionally, enter a description of this Event Source.
IP Address 2. Enter the IP address of the device that will send Syslog events to W-ClearPass.
Type 3. From the drop-down, select the Event Source Type.
Vendor 4. From the drop-down, select the Event Source Vendor.
Enable 5. Select this check box to enable the device as an Event Source.
Table 384: Configuring the Event Source Parameters
6. When finished, click Add.
The Event Sources page now displays the new Event Sources (see Figure 726).
Figure 726: Event Sources Page
The IPaddress displayed in Figure 726 is the IP address and host name of the Juniper SRX gateway that
sends Syslog events to W-ClearPass.
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Configuring Processing for Ingress Events | 733