Users Guide

Figure 799: Specifying the Insight File Transfer Settings
2. In the File Transfer Settings section, enter the appropriate values as described in Table 406.
3. When finished, click Save.
Parameter Action/Description
Host 1. Specify the IP address of the destination host FTP server.
Protocol 2. Specify the protocol to be used to upload the generated reports to a FileStore.
You can select from the following protocols:
n SCP (Session Control Protocol)
n SFTP (SSH File Transfer Protocol)
Port 3. Specify the destination port number.
The default destination port is 22.
Username/Password 4. Enter the username and password of the host FTP server.
Timeout 5. Specify the timeout value in seconds.
The default value is 30 seconds.
Remote Directory 6. Specify the location where the generated reports are to be copied.
If the remote directory location is same as default root of FTP, you can leave
this field blank.
NOTE: To copy reports to a remote directory, you must enable the Reports >
Create New Report > Enable remote copy option.
Table 406: Insight File Transfer Parameters
Testing File Transfer Configuration
When you have configured the Insight file transfer settings, you can then test to see if file transfer is
operational.
To test the Insight file transfer configuration:
1. Review the File Transfer Settings to ensure they are correct.
2. Click the Test button.
You see the message: File Transfer Settings testing in progress...
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide W-ClearPass Insight Reports | 815