Administrator Guide

6 | Powering Up and Configuring Policy Manager Hardware Dell Networking W-ClearPass Policy Manager | Getting Started Guide
Requirement Value for Your Installation
Hostname (Policy
Manager server)
Management Port IP
Address
Management Port
Subnet Mask
Management Port
Gateway
Data Port IP Address
(optional)
NOTE: The Data Port IP Address must not be in the same subnet as the
Management Port IP Address.
Data Port Subnet Mask
(optional)
Data Port Gateway
(optional)
Primary DNS
Secondary DNS
NTP Server (optional)
Table 2: Required Information
Initial Setup Procedure
Perform the following steps to set up the Policy Manager appliance:
1. Connect and power on
Connect the serial port on the appliance to a terminal using the null modem cable provided, and power on
the appliance. The appliance is now available for configuration.
Use the following parameters for the serial port connection:
l Bit Rate: 9600
l Data Bits: 8
l Parity: None
l Stop Bits: 1
l Flow Control: None
2. Log in
Use the following preconfigured credentials to log in to the appliance. (You can create a unique
appliance/cluster administration password later.)
login: appadmin
password: eTIPS123
This initiates the Policy Manager Configuration Wizard.
3. Configure the Appliance