Users Guide

181 Dell Networking W-ClearPass Policy Manager 6.2 | User Guide
This section contains the following topics:
l "Built-In Audit Servers" on page 181
l "Custom Audit Servers" on page 183
l "Nessus Scan Profiles" on page 186
Built-In Audit Servers
When configuring an audit as part of an Policy Manager Service, you can select the default Nessus ([Nessus Server]) or
NMAP ([Nmap Audit]) configuration.
Adding Auditing to a Policy Manager Service
1. Navigate to the Audit tab
l To configure an audit server for a new service (as part of the flow of the Add Service wizard), navigate to
Configuration > Services. Select the Add Services link. In the Add Services form, select the Audit tab.
You must select the Audit End-hosts check box on the Services tab in order for the Audit tab to display.
l To modify an existing audit server, navigate to Configuration > Posture > Audit Servers, then select an audit
server from the list.
2. Configure auditing
Complete the fields in the Audit tab as follows:
Figure 173 Audit Tab