Users Guide

Table 127: Virtual IPSettings Parameters
Parameter Description
Virtual IP Enter the IP address you want to define as the virtual IP address.
Node Select the servers to use as the primary and secondary nodes.
Interface Select the interface on each server where virtual IP address should be bound.
Subnet This value is automatically entered. you do not need to change it.
Enabled Select the check box to enable the Virtual IP address.
Make Subscriber
In the Policy Manager cluster environment, the Publisher node acts as master. An Policy Manager cluster can contain
only one Publisher node. Administration, configuration, and database write operations may occur only on this master
node.
The Policy Manager appliance defaults to a Publisher node unless it is made a Subscriber node. Cluster commands can
be used to change the state of the node, hence the Publisher can be made a Subscriber. When it is a Subscriber, you
will not see this link.
Navigate to the Administration > Server Manager > Server Configuration page, and click on the Make Subscriber
link.
Figure 224 Add Subscriber Node
Table 128: Add Subscriber Node
Container Description
Publisher IP Specify publisher address and password. Note that the password
specified here is the password for the CLI user appadmin
Publisher Password
Restore the local log database
after this operation
Enable to restore the log database following addition of a subscriber
node.
Dell Networking W-ClearPass Policy Manager 6.2 | User Guide 228