Administrator Guide

The following table displays the Audit tab parameters:
Parameter Description
Audit Server Select the audit server from the following options:
l Nessus Server - Interfaces with Policy Manager primarily to perform
vulnerability scanning
l Nmap Audit - Performs specific audit functions
You can click the View Details button to view the Policy Manager Entity
Details pop-up with the summary of audit server details. Click the Modify
button to view the Summary tab with audit server details.
Audit Trigger Conditions Select an audit trigger condition.
Known end hosts are the clients that are found in the authentication source(s)
associated with this service.
Action after audit Specifies the audit that can be performed only after the MAC authentication
request is completed and the client has acquired an IP address through DHCP.
Once the audit results are available, Policy Manager re-applies policies on the
network device in one of the following ways:
l No Action - The audit does not apply policies on the network device after
completing this audit.
l Do SNMP bounce - This option bounces the switch port or forces an 802.1X
re-authentication (both done using SNMP). Bouncing the port triggers a new
802.1X or MAC authentication request by the client. If the audit server
already has the posture token and attributes associated with this client in its
cache, it returns the token and the attributes to Policy Manager.
l Trigger RADIUS CoA action - This option sends a RADIUS CoA command
from Policy Manager to the network device.
Table 55: Dell 802.1X Wireless Service - Audit Tab Parameters
Profiler Tab
The Profiler tab is not displayed by default. To access this tab, select the Profile Endpoints check box from
the More Options field on the Services tab. The following figure displays the Profiler tab:
Figure 78: Dell 802.1X Wireless Service - Profiler Tab
Dell Networking W-ClearPass Policy Manager 6.5 | User Guide Services | 131