Administrator Guide

182 | Authentication and Authorization Dell Networking W-ClearPass Policy Manager 6.5 |User Guide
Configuration Tab
The Configuration tab shows the filter and attributes configured in the Filter and Attributes tabs
respectively. From this tab, you can also manually edit the filter query and attributes to be fetched.
The following figure displays the Configure Filter - Configuration tab:
Figure 125: Configure Filter Popup - Configuration Tab
Modify Default Filters
When you add a new authentication source of type Active Directory or LDAP, a few default filters and
attributes are populated. You can modify these pre-defined filters by selecting a filter on the Authentication
> Sources >Attributes tab. This opens the Configure Filter page for the specified filter.
A minimum of one filter must be specified for the LDAP and Active Directory authentication source. This filter is used
by Policy Manager to search for the user or device record. If not specified, authentication requests are rejected.
Figure 126: Modify Default Filters - Configuration Tab