Administrator Guide

250 | Posture Dell Networking W-ClearPass Policy Manager 6.5 |User Guide
The following figure displays the Peer To Peer health class configuration page:
Figure 203: Peer to Peer Page
The following table describes the Peer to Peer parameters:
Parameter Description
Auto
Remediation
Enable to allow auto remediation for service checks (Automatically stop peer to peer
applications based on the entries in Applications to stop configuration).
User
Notification
Enable to allow user notifications for peer to peer application/network check policy violations.
By Application /
By Network
Select the appropriate radio button to select individual peer to peer applications or a group of
applications that use specific p2p networks.
Available
Applications
This scrolling list contains a list of applications or networks that you can select and move to the
Applications to stop panel.
Click the >> or << to add or remove, respectively, the applications or networks from the
Applications to stop box.
Table 130: Peer to Peer Page
Patch Management
In the Patch Management page, you can specify that a patch management application must be on and
allows drill-down to specify information about the patch management application. Click A patch
management application is On to configure the patch management application information.
The following figure displays the Patch Management page:
Figure 204: Patch Management Page (Overview - Before)
When enabled, the Patch Management detail pop-up appears.