Administrator Guide

426 | Administration Dell Networking W-ClearPass Policy Manager 6.5 | User Guide
The following figure displays the Create Tunnel pop-up:
Figure 398: Create Tunnel
The following table describes the Create Tunnel parameters:
Parameter Description
Display Name Specify the name for the tunnel interface. This name is used to identify the tunnel in the list
of network interfaces.
Local Inner IP Local IP address of the tunnel network interface.
Remote Outer IP IP address of the remote tunnel endpoint.
Remote Inner IP Remote IP address of the tunnel network interface.
Enter a value here to automatically create a route to this address through the tunnel.
Local Outer IP
(Optional)
Local IP address of the tunnel endpoint.
Create/Cancel Commit or dismiss changes.
Table 244: Create Tunnel Parameters