Administrator Guide

See http://csrc.nist.gov/groups/STM/cmvp/documents/140-1/140val-all.htm#1747 for details on the FIPS 140-2
validated cryptographic module.
You can enable FIPS mode in ClearPass Policy Manager during installation using the CLI or post-installation
using the Web UI. The following figure displays the prompt to enable FIPS Mode using the CLI:
Figure 402: Enabling FIPS Mode
After enabling FIPS mode using the CLI commands, you can verify whether FIPS mode is enabled or not in the
Configuration Summary page. The following figure displays the Configuration Summary page:
Figure 403: FIPS Mode - Configuration Summary
Dell Networking W-ClearPass Policy Manager 6.5 | User Guide Administration | 431