Users Guide

126 | Services Dell Networking W-ClearPass Policy Manager 6.3 |User Guide
Modifying Services
Navigate to the Configuration >Services page to view available services. You can use these service types as
configured, or you can edit their settings.
Figure 81: Service Listing Page
To modify an existing service, click on its name in the Configuration > Services page. This opens the Services > Edit
- <service_name> form. Select the Service tab on this form to edit the service information.
Figure 82: Services Configuration
The following fields are available on the Service tab.
Parameter Description
Name Enter or modify the label for a service.
Description Enter or modify the service description (optional).
Type This is a non-editable label that shows the type of service as it was originally configured.
Status This non-editable label indicates whether the service is enabled or disabled.
NOTE: You can disable a service by clicking the Disable button on the bottom-right corner
of the form. This button will toggle between Enable and Disable depending on the
Service's current status.
Monitor
Mode
This non-editable check box indicates whether authentication and health validation
exchanges will take place between endpoint and Policy Manager, but without enforcement.
In monitor mode, no enforcement profiles (and associated attributes) are sent to the
network device.
Table 44: Service Page (General Parameters)