Users Guide

222 | Posture Dell Networking W-ClearPass Policy Manager 6.3 |User Guide
Parameter Description
Auto
Remediation
Enable to allow auto remediation for service checks (Automatically stop peer to peer
applications based on the entries in Applications to stop configuration).
User
Notification
Enable to allow user notifications for peer to peer application/network check policy
violations.
By
Application /
By Network
Select the appropriate radio button to select individual peer to peer applications or a
group of applications that use specific p2p networks.
Available
Applications
This scrolling list contains a list of applications or networks that you can select and move
to the Applications to stop panel.
Click the >> or << to add or remove, respectively, the applications or networks from the
Applications to stop box.
Table 108: Peer to Peer Page
Patch Management
In the Patch Management page, you can specify that a patch management application must be on and allows drill-
down to specify information about the patch management application. Click A patch management application is On
to configure the patch management application information.
Figure 203: Patch Management Page (Overview - Before)
When enabled, the Patch Management detail page appears.
Figure 204: Patch Management Page (Detail 1)
Click Add to specify PM Product Name, Product Version, Status Check and Install Level Check information.
Figure 205: Patch Management Page (Detail 2)
When you save your patches configuration, it appears in the Patch Management page list.
Figure 206: Patch Management Page (Overview - After)