Users Guide

234 | Audit Servers Dell Networking W-ClearPass Policy Manager 6.3 |User Guide
l "Built-In Audit Servers" on page 234
l "Custom Audit Servers" on page 236
l "Post-Audit Rules" on page 242
Built-In Audit Servers
When configuring an audit as part of an Policy Manager Service, you can select the default Nessus ([Nessus Server]) or
NMAP ([Nmap Audit]) configuration.
Add Auditing to a Policy Manager Service
1. Navigate to the Audit tab from one of the following locations:
l To configure an audit server for a new service (as part of the flow of the Add Service wizard), navigate to
Configuration > Services. Select the Add Services link. In the Add Services form, select the Audit tab.
You must select the Audit End-hosts check box on the Services tab in order for the Audit tab to display.
l To modify an existing audit server, navigate to Configuration > Posture > Audit Servers, then select an audit
server from the list.
2. Configure auditing. Complete the fields in the Audit tab as follows:
Figure 219: Audit Tab