Users Guide

Figure 199: Firewall Page (Detail 1)
When enabled, the Firewall detail page appears.
Figure 200: Firewall Page (Detail 2)
When you save your Firewall configuration, it appears in the Firewall page list.
Figure 201: Firewall Page (Overview After)
Interface Parameter Description
Firewall
Page
l A Firewall
Application
is On
l Auto
Remediation
l User
Notification
l Uncheck to
allow any
product
l Check the Firewall Application is On check box to enable testing of
health data for configured firewall application(s).
l Check the Auto Remediation check box to enable auto remediation
of firewall status.
l Check the User Notification check box to enable user notification of
policy violation of firewall status.
l Uncheck the Uncheck to allow any product check box to check
whether any firewall application (any vendor) is running on the end
host.
Firewall
Page
(Detail 1)
l Add
l Trashcan
icon
l To configure firewall application attributes for testing against health
data, click Add.
l To remove configured firewall application attributes from the list, click
the trashcan icon in that row.
Firewall
Page
(Detail 2)
Product/Version Configure the specific settings for which to test against health data. All of
these checks may not be available for some products. Where checks are
not available, they are shown in disabled state on the UI.
l Select the firewall product - Select a vendor from the list
l Product version is at least - Enter the version of the product.
Table 107: Firewall Page
Dell Networking W-ClearPass Policy Manager 6.3 | User Guide Posture | 225