Users Guide

228 | Posture Dell Networking W-ClearPass Policy Manager 6.3 |User Guide
Interface Parameter Description
Patch
Management
Page (Detail
2)
Product/Version Configure settings for which to test against health data. All checks
might not be available for some products. Where checks are not
available, they are shown in disabled state on the UI.
l Select Patch Management product: Select a vendor. This option
is
only
enabled if the Product-specific checks checkbox is
checked.
l Product version is at least: Enter version number. This option is
only
enabled if the Product-specific checks check box is checked.
l Status Check Type: Select No check, Enabled, or Disabled. This
option is always available.
l Install Level Check: Select No Check, All, Selected on Server, or
Security. This option is
only
enabled if the Product-specific check
box is checked. For Microsoft SCCM, selecting All, Selected on
Server, or Security will return the full list of all missing patches.
n All: Check for all missing patches, and search for all available
patches.
n Selected on Server:Check only for the patches pre-selected
on the server. Some Patch Management products can push
the patches to the endpoint device. This option provides the
ability to check for only the pre-selected patches.
n Security: Check only for security updates. Some of the
products can install only security-related patches.
NOTE: If you select the Microsoft Windows Update Agent from the
Select Patch Management product list and you select an option from
the Install Level Check list, the results are listed below:
n All: Returns the full list of missing patches.
n Selected on Server:Returns a list of missing patches that are
pre-selected on the server site.
n Security: Returns a list of missing patches that Microsoft
classifies as Security Updates.
Table 109:
Patch Management Page (Continued)
Windows Hotfixes
The Windows Hotfixes page provides a set of widgets for checking if specific Windows hotfixes are installed on the
endpoint.
Figure 207: Windows Hotfixes Page