Administrator Guide

148 | Deploying W-ClearPass Clusters Dell Networking W-ClearPass Deployment Guide
Table 26: Configuring Add Subscriber Node Parameters
Parameter Action/Description
Publisher IP 1. Enter the Publisher node's IP address.
Publisher Password 2. Enter the appadmin (CLI) password.
Restore the local log database after this
operation
3. To restore the log database following the addition of a Subscriber
node, select the check box.
Do not backup the existing databases
before this operation
4. Select this check box only if you do not require a backup to the
existing database.
5. Be sure to note the warnings on this dialog and respond as needed.
6. When finished, click Save.
You will see the message: Adding node as subscriber to <IP_address>'s cluster.
When the process completes, the following messages are displayed:
Figure 128 Completing Subscriber Setup
7. To complete the Subscriber setup, log back into the new Subscriber node.
When you log into the Publisher node or the Subscriber node, the Policy Manager Dashboard presents the
updated cluster status:
Figure 129 Cluster Status: Subscriber Node Added