Administrator Guide

160 | Deploying W-ClearPass Clusters Dell Networking W-ClearPass Deployment Guide
You receive the message:
<n> parameters updated successfully...Please refresh to continue.
5. Refresh the page.
Cleanup Intervals Settings for High Capacity Guest Mode
When you enable High Capacity Guest mode, the values for the Cleanup Intervals parameters are set
automatically to ensure that W-ClearPass can support the significantly higher numbers of guests by making
sure the amount of data stored in W-ClearPass is kept to a minimum (as shown in Figure 144).
To see the Cleanup Interval settings for High Capacity Guest mode:
1. Navigate to the Cluster-Wide Parameters > Cleanup Intervals tab.
The Cleanup Intervals dialog opens.
Figure 144 High Capacity Guest Mode Values for the Cleanup Intervals Parameters
Table 28 shows the value for each Cleanup Intervals parameter while in High Capacity Guest mode.
Table 28: Cleanup Interval Parameter Values in High Capacity Guest Mode
Cleanup Intervals Parameters Values for HCG Mode
Maximum inactive time for an endpoint HGC mode value: 0 days
Cleanup interval for Session log details in the
database
HGC mode value: 3 days
Cleanup interval for information stored on the disk. HGC mode value: 7 days
Known endpoints cleanup interval HGC mode value: 3 days