Administrator Guide

Figure 73 Setting 3576 Server Parameters
5. Specify the parameters for the RFC 3576 server.
a. Key parameter: Enter and verify the RADIUS shared key.
This key value is the same RADIUS key value configured for the mobility controller.
To enable communication between the mobility controller and the W-ClearPass server, the values for RADIUS key
configured on the mobility controller and the RADIUSshared secret configured on the W-ClearPass server must be
identical.
b. Radsec check box: Enable or disable RADIUSover TLS for this server.
6. When finished, click Apply.
The following message is displayed: Configuration Updated successfully.
The new RFC3576 server is listed on the Servers list.
Using the CLI
Use the following commands to configure an RFC 3576 server using the CLI:
aaa rfc-3576-server <server_IP_address>
key <string>
For example:
(controller) (config) #aaa rfc-3576-server 10.100.8.32
(controller) (RFC 3576 Server "10.100.8.32") #key employee123
Adding an SSID to the Mobility Controller for 802.1X
Authentication
This section describes how to create and configure a Service Set Identifier (SSID) to the mobility controller for
802.1X authentication.
This section contains the following information:
l SSID Profile Overview
l Adding an SSID to the Mobility Controller
SSID Profile Overview
An SSID (Service Set Identifier) is the name of the network or Wireless LAN that clients see. An SSID profile
defines the name of the network, authentication type for the network, basic rates, transmit rates, SSID
cloaking, and certain wireless multimedia settings for the network.
Dell Networking W-ClearPass Deployment Guide
Preparing the Mobility Controller for W-ClearPass PolicyManager Integration
| 85