Administrator Guide
86 | Preparing the Mobility Controller for W-ClearPass PolicyManager Integ-
ration
Dell Networking W-ClearPass Deployment Guide
ArubaOS supports different types of the Advanced Encryption Standard (AES), Temporal Key Integrity Protocol
(TKIP), and wired equivalent privacy (WEP) encryption. AES is the most secure and the recommended
encryption method.
Most modern devices are AES capable, and therefore AES should be the default encryption method. Use TKIP
only when the network includes devices that do not support AES. In these situations, use a separate SSID for
devices that are only capable of TKIP.
Adding an SSID to the Mobility Controller
This section assumes that the mobility controller's basic configuration has been completed as described in the
previous sections of this chapter, and that the access points (APs) have been provisioned.
To add an SSID for 802.1X authentication:
1. On the mobility controller, navigate to Configuration > WIZARDS > Campus WLAN.
The Configure WLAN wizard opens.
Figure 74 Specifying the Wireless LAN
2. From the AP Groups pane, select the appropriate AP group, or click New to create a new AP group.
3. From the WLANs for <name> pane, select the Wireless LAN you wish to use, or click New to create a new
Wireless LAN.
4. In the Create New WLAN Named dialog, enter the name of the new Wireless LAN.