Administrator Guide

Interface
Parameter
Description
l Scan Interval: Configure the time interval after
which OnGuard Agent should check for missing
patches. You can configure the time period in hours,
days, weeks, or months. The default scan interval is
1 hour. This field is disabled if you selected No
Check from the Install Level Check Type field.
Table 146: Patch Management Page Parameters (Continued)
Windows Hotfixes
The Windows Hotfixes page provides a set of widgets for checking if specific Windows hotfixes are installed
on the endpoint. The following figure displays the Windows Hotfixes health class configuration page:
Figure 260: Windows Hotfixes Page
The following table describes the Windows Hotfixes parameters:
Parameter Description
Auto
Remediation
Enable to allow auto remediation for hotfixes checks (Automatically trigger updates of
the specified hotfixes).
User
Notification
Enable to allow user notifications for hotfixes check policy violations.
Monitor
Mode
Click to enable Monitor Mode.
Available
Hotfixes
The first scrolling list lets you select the criticality of the hotfixes. Based on this
selection, the second scrolling list contains a list of hotfixes that you can select and
move to the Hotfixes to be present panel (using their associated widgets).
Click the >> or << to add or remove, respectively, the hotfixes from the Hotfixes to run
boxes.
Table 147: Windows Hotfixes Page Parameters
USB Devices
The USB Devices page provides configuration to control USB mass storage devices attached to an endpoint.
Dell Networking W-ClearPass Policy Manager 6.6 | User Guide Posture | 291